What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 00:33

[old diagram got deleted by accident]
One is “what exactly is in a ‘surge protector’ ? ”
Here is a simplified AC power diagram.
What transforms the philosophical intellect?
What does a fuse do?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
A fuse is a non-resetable over current circuit protector.
Why do so many 18 to 29-year-old men struggle in dating?
What is lightning?
He then describes the function of a fuse.
A circuit breaker is similar, but is resettable.
eight
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
He then asserts :
Barnstars:
2024–10–14 [Omar Gharbi Omar Gharbi ]
This device then solves the entire problem.
What can I do to deal with disrespectful children?
An AC voltage/ current source, and an ac inductive load.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
In schematic diagrams this is the symbol for a fuse:
How do you get started in bestiality with a dog as a male?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But it can get overloaded, and no longer works.
Why can’t my wife just accept the fact that I’m going to cheat?
At least they know the answer if they wanted it.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The third is lightning and “how it gets conducted into a home.”
There are two important concepts here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is 'the assistant's answer'
The bolt then partially travels down the line to your home.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Have you been arrested or investigated?
These devices are installed between the “hot” and “neutral” and protective ground.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is the central theme of the entire Bible in one word (if possible)?
Edit 2024–10.
but I think this circuit , shows a few more pieces.
a photo is worth a thousand words.
It also is a device that limits the change in current flow.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–10[John johnson John Johnson ]
It seems Mohan does not understand the difference between a comment and an Answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
How do flat Earthers explain the existence of other spherical planets?
so, what happens?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
For this case there are devices called Metal oxide varistors (MOV).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The other is “what does a “fuse” do?”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is where the MOV conducts again, and dissipated the energy.
This one hit behind the barn.
Upvotes:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
At one ohm, the resistor has a maximum of 1 watt power.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
[image of Common-mode choke]
He then describes Rainy Season and Lightning.
First Sentence:
There are three different concepts here that are getting confused.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–16 [ OO OLAOYE OYEBODE ]
Now when you have a certain ac resistance, then a current flows in a loop.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
I post the exact comment here.
(Dc diagram shown, AC is similar).
what exactly is a ‘surge’ protector?
Because the load is inductive, the current lags the voltage.(by a bit).
nine
but this device (an Inductor) … impedes the rapid changes in the current.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
One
These are simplified answers to the original question, and does not change anything I wrote above.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
the problem then depends on "how fast does the fuse operate?".
This is where this question deviates from being a 'generic' question, and becomes more specific.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.